-
Place your Goldwing on its center stand.
-
Remove the pilot's backrest from the bike (if
applicable)
-
Lay the seat cover over the seat on your Goldwing.
Stretch and pull the perimeter bungee cord over the rear of the seat
(fig. 1). Work the bungee around and under the front and sides of
the seat.
-
Stretch the front of the seat cover forward and work
it over the front of the seat. You may need to lift up slightly on
the sides of the seat. The bungee cord should be under the front and
sides of the seat.
-
Fold the back (passenger) seat cover area to the
front. Take the middle bungee cord (fig. 2) and stretch it around
the driver's lumbar support (fig. 3). Push the bungee back as far as
possible.
-
Slide all the excess driver's seat material under
the lumbar support.
-
Pull the remaining material toward the rear of the
passenger's seat. Turn the back of the seat cover inside out and
roll it over the back of the passenger seat.
-
Take dowel pin attached to rear of the seat cover
(fig. 4) and guide through drain hole located in lower rear of
passenger seat (fig. 5)
-
To install passenger's backrest cover, start at the
top of the backrest and pull the cover downward - working the cover
between the backrest and the trunk. Install the pilot's
backrest in the same manner after installing.